Circling back to finish the landing light lens. With the experience on the other lens, I’m ended up cutting this lens to the “proper” dimensions this time. (The directions are correct even if you don’t think they are. Go figure!) Still debating if I will purchase a replacement lens for the right wing or not as the other does work just fine.
With the lens cut and fitted, I go ahead and mount the landing light in the wing (off camera) and struggle to figure out how to actually screw in the landing light lens as I can’t get behind it to apply any pressure. The lightbulb moment was when I realized I needed to use tape on the lens to help provide the outward pressure so I can screw in the lens.
With the lens installed (and protected by additional tape), I then got some assistance from my wife to cleco the leading edge to the wing spar. Getting the ribs clecoed into place I then begin riveting the leading edge to the spar. As a small note on the blind rivets, not sure if it’s just my blind rivet squeezer, but I really don’t like setting blind rivets.
With all the ribs riveted to the spar, I squeeze the skin rivets then ask my wife for assistance to rivet the top of the leading edge. Easy enough and once done I get to stand back and admire my progress. Plan on getting the other wing done shortly as I approach my fuselage crate date.